نقد و بررسی :
نمایشگر NOKIA 5110 84 X 48دارای بک لایت
سازگاری کامل با برد آردوینو
ولتاژ کاری: 3 تا 5 ولت
ارتباط با میکروکنترلر ها از طریق پروتکل SPI
قابلیت نمایش چهار ردیف کاراکتری
LCD5110 Module:
Power supply voltage:2.7V-3.3V,5V is OK,but part of the screen becomes black when tested
Data interface level:2.7-5V
Backlight power supply voltage:highest 3.3V
Module size:43.6mm x 43.1mm(width X height)
Installation diameter:2mm
Backlight:White
Document for Download:Data
1RST——— reset
2CE————chip selection
3DC———–data/commands choice
4DIN———–serial data line
5CLK————serial Clock Spee
63.3V————VCC
7LIGHT——— backlight control terminal
8GND———–power negative
Features:
84 X 84 dot matrix LCD,can show 4 lines of characters
Use serial interface communicate with the master processor,the number of interface signal line reduced greatly, only 8 signal lines including power and GND.Support different types of MCU,such as the SPI,MCS51 serial mode 0 of AVR.Transfer rate up to 4Mbps,can full speed write display data without waiting time.
Can use the conductive glue to connect the module with the printed board,without connecting cable.The metal hooks on the module can fix the module on the printed board,which is very easy to install and replace.
LCD controller/driver chip has been bound to LCD chip,the volume of LCD is small
Low power supply,the working current in normal situation is lower than 200A,and has power-down mode
Shipping Included:
1PCS*for Nokia 5110 LCD Disply Module
0/5
(0 امتیاز )
دیدگاه
دیدگاهی ثبت نشده.
اولین نفری باشید که نظر می دهید برای “نمایشگر NOKIA 5110 84 X 48دارای بک لایت” لغو پاسخ
دیدگاهی ثبت نشده.